SPEB-7
SH Adhesive. (Synthetic Resin Adhesive)
Customers can avail from us Synthetic Resin
Adhesive in desired quality grades at market
leading prices. These adhesives are pure in
composition, highly effective and are widely
reckoned for their strong adhesion which remains
intact even in extreme conditions. Our product
finds applications in varied furniture, wood,
packaging, handy craft industries and applied on
paper bags, wall paper and book binding.
Application
Major
Applications :
SPEB-7 SH Adhesive product offers excellent
bonding strength between different types of wood
assembly- bonding of Wood, Plywood, Laminates,
Veneers, Particle Boards, Block board, MDF and
other Wood Substitutes.
Application
Industries
•
Packaging Industries
•
Handicraft Industries
•
Wallpaper and Book binding.
Method of Use
All surfaces to be bonded should be dry and free from dust, dirt, oil etc.
Oil, grease and other contaminants can be removed by wiping with solvent (IPA) and Dry properly.
Spread the substrate to-be-bonded on a flat surface
Stir SPEB-7 SH Adhesive (Synthetic Resin Adhesive) thoroughly, before using / applying
Apply adhesive generously in a uniform thin film on both or one surface (as required), with the help of Glue Spreader or Wooden Spatula.
Position surfaces carefully before assembly - Avoid repeated repositioning of two Substrates after bonding.. This will disturb formation/ Curing process. However, minor adjustment is possible after contact.
Press both the surfaces together applying uniform pressure and keep under pressure till the adhesive dries completely.
Handling strength can be achieved within 2.5 to 3 hrs.
The adhesive dries completely in 6-7 hrs under normal temperature (16-45 deg.c) & relative humidity 60%) to make the bonds.
Coverage is independent upon method by which the adhesive is applied. More adhesive (Lower coverage) is recommended if very soft wood or very porous surfaces (Like Pine, MDF, particle board etc.) to be bonded.
Excess adhesive pressed outside the joints should be wiped out with clean, wet, lint free cloth. The applicators are to be cleaned with clean water, post application, before the adhesive starts curing.
Note
:
• Adhesive cannot be cleaned off rollers or brushes after it has completely dried.
• The moisture content in the wood should not be more than 12%
Precautions
:
Don't apply thick layer of adhesive on the substrate
Don't add water into adhesive (for Wood Based Applications),
Clamp properly both the substrates
Don't move bonded substrates till handling strength achieved
